Published on Sep 16, 2019
The objective of our project is to determine which of four different salt species in solution is the best conductor of electricity. We devised this experiment because we want to build a Tesla Coil that uses a saltwater tank capacitor. Most coil builders use sodium chloride in the tank.
Our current experiment, on ionic species and electrical conductivity (EC), provides us with the first information we need.
Based on our prior research, we believed that divalent salts would be more conductive than the monovalent salts. During our research we also learned that solution EC is affected by temperature and concentration, which we carefully controlled.
We tested four salt solutions, two divalent and two monovalent: calcium chloride (CaCl2), sodium sulfate (Na2SO4), sodium chloride (NaCl) and sodium bicarbonate (NaHCO3).
We began each replicate with 0.1 molar (0.1M) solution of each salt and then made serial dilutions at 0.01M and 0.001M.
We made 5 replicates of each salt at each of the three concentrations. Prior to measuring the replicate EC values, we calibrated the EC meter each time with two standard solutions (12.88mS and 1.413mS).
We recorded the EC and temperature of each replicate for 1 min. or until the EC readings stabilized.
Based on the experimental results, we ranked the salts from highest to lowest average EC values as: CaCl2, Na2SO4, NaCl, and NaHCO3.
The small range and standard deviation values showed there was relatively little variation between each of the replicate values.
Our project data supported our hypothesis that the divalent salts, CaCl2 and Na2SO4, would have higher EC values than the monovalent salts, NaCl and NaHCO3.
CaCl2 had the highest EC value at 0.1M of all the salts we tested. NaCl had higher EC values than NaHCO3 at all three concentrations.
Also, each salt solution showed a slightly different relationship between concentration and conductivity. So, if we want to build a good saltwater capacitor for our Tesla Coil, we should use CaCl2 instead of NaCl in the tank.
If we were more cautious and did not want to potentially burn down the city, then we would use NaHCO3, a poor conductor, in the capacitor.
We would like to test the salts at higher concentrations and also test some other salt species, especially a trivalent salt, such as aluminum chloride (AlCl3).
This project shows that calcium chloride should be better than sodium chloride when used in salt water tank capacitors based on its higher EC value at equimolar concentrations.
Science Fair Project done By Nikki A. Teran