This project is developed for the users to control the speed of a motor through Intel processor.
When the Processor is booted, it gets opterational data from a floppy drive. The controlling and other data are also stored in the floppy disk. It requires no Hard disk.
The user can input the speed of the motor through key pad. The key pad is connected with the serial port. According to the input, the processor sends signal through parallell port. The microcontroller receives the signal and controls the controlling unit.
The controlling unit drives the motor in the particular speed. The relay is used to reverse the motor. By this way the user can control the entire operation of the motor.
This type of controller can be used in areas where human cannot enter. It is also used in areas where the motor is to be controlled in a secured manner. In those areas, a computer is enough to control the entire operation of the motor.